Shop by Category
page id: code-3-led-hideaway-kit
Able2 Sho-Me - Switch Box w/ Four 20A Switches 05.4000
You Pay: $57.85
Streamlight Jr. Reach C4 LED Light - 71600
You Pay: $37.41
Able2 Sho-Me - Undercover Siren - Wail, Yelp & Air Horn 30.2109
You Pay: $131.91
Code 3 PSE LED Front Hideaway System for Crown Victoria - Red & Blue
Discontinued - No Longer Available - Out of Stock
Uses Code 3 Optix "3-up" LED module to provide spectacular warning signal. Virtually maintenance free - rugged and reliable LED performance with a 5-year warranty (1 year on controller). Nearly impossible to detect in side markers or tail lights until activated.The flasher is potted for weather protection and suitable for trunk or under-hood mounting. Up to 15 user-selectable flash patterns.
•Each system contains: 1 driver & 1 passenger side LED module, Hide-a-Way LED flasher, 2-15ft cables.
•Designed for 2003-2011 Ford Crown Victoria.
•Each 3-up module has a wide center optic with a directional optic on either side.
•Easy to install - each module comes pre assembled with a 15-ft cable.
•70 flashes per minute minimum. Fast mode rate is 100 flashes per minute.
•1 amp maximum
Programming the desired flash pattern (or operation mode ) is done with the Program terminal on the control box. You can scroll through the nineteen available flash patterns, by momentarily grounding the Program terminal until you arrive at the desired operation mode. Momentary grounding of the Program terminal can be accomplished either by momentarily touching the terminal to ground through a temporary jumper wire or through a permanently connected momentary push-button switch.
The unit will come on in the default Cycle-flash mode at the time of first power-up, until the desired flash pattern is programmed. The operating flash pattern can then be changed by programming the desired pattern into the unit, the unit will continue to operate in the same mode every time the unit is turned off and turned back on. The operating flash pattern can be changed at will for any number of times.
The unit can be reset back to the default flash pattern (cycle-flash) by grounding the Program terminal for about 8-10 seconds and then releasing it. This can be done while operating in any of the flash modes.
Cycle Flash Quad Flash
Single Flash Triple Flash
Double Flash Double Flash
Triple Flash Single Flash
Quad Flash Pursuit Flash
Fast Single Flash
Fast Double Flash
Fast Triple Flash
Fast Quad Flash
Quad Pop Flash
Triple Pop Flash
Double Pop Flash
Wig-Wag Flash Alt.
Note: All modes flash at a rate of 70 fpm minimum. Fast modes flash at a rate of 100 fpm minimum.